Xylem EZ100 Sensor Display Manual de usuario descargar pdf (Pagina 9)

Global Water

800-876-1172 • globalw.com

- 9 -

e. Set DIP Switches 6-8 to place the decimal point in the correct position

according to the following table:

Decimal Location SW6 SW7 SW8

9999 Off Off Off

9.999 On Off Off

99.99 Off On Off

999.9 Off Off On

f. Set up the sensor for its minimum output current or put the current

loop meter in “Simulate” mode and set it for the minimum output

current of the sensor that will be connected to the EZ100 (4.000mA,

3.986mA, etc). If using a current loop meter, connect the red lead to

terminal S1 and the black lead to terminal S2 according to Figure 1 on

page 5.

g. While holding down the “Display” button on the front panel of the

meter, adjust R3 until the display reads the correct minimum reading.

h. Set up the sensor for its maximum output current or set the current

loop meter for the output current of the sensor that will be connected to

the EZ100 (19.000mA, 19.064mA, 20.000mA, etc).

i. While holding down the “Display” button, adjust R7 until the display

reads the correct maximum reading.

j. Repeat steps f - i and confirm the display reads the correct low and

high values. Readjust R3 and R7 as necessary until the correct

display is achieved without adjustment.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Xylem EZ100 Sensor Display Manual de usuario Pagina 9