
Operation Lab 850
30
ba75553e03 01/2006
4.4.3 Downloading calibration data
While the calibration data is being displayed, you can:
1 Press <CAL_> to display the calibration data.
The following data is displayed consecutively for 10 seconds
each:
date, zero point, slope.
! press <OK> to display further calibration data
(date, zero point, slope)
! press
<▲><▼>
to switch over the unit of the zero point (Asy)
(while the zero point is being displayed)
! press
<▲><▼>
to switch over the unit of the slope (Slo)
(while the slope is being displayed)
Comentarios a estos manuales